CONDUIT HANGERS

on Thursday, 26 April 2012

CONDUIT HANGERS




1. MOUNT HANGER EITHER HORIZONTALLY OR VERTICALLY.
2. RUN CONOUIT THROUGH HANGER.
3. TIGHTEN SCREW INTO HANGER.


















'Now with Slotted Hex #3 Philips &: #2 Robertson
Combo Head.
Manufactured with retained bolt and built-in nut










"CD "37" SERIES IS MANUFACTURED FOR USE
WITH 3/8" 80LT OR THREADED ROD.













WITH SLOTTED HEX #3 PHILIPS & #2
ROBERTSON COMBO HEAD






.

"STAINLESS STEEL SERIES USES A NUT.
SUPPLIED WITH ROUND HEAD BOLT

















1/2" caddy clip fit for 3/4" condiut pipe
.

3/4" bar saddle fit for 3/4" condiut pipe






I prefer caddy to do conduit installation instead from using the old type Bar saddle.because during the cable pulling the pipe will not escape from the clutches caddy than saddle bar.


Ranking: 5

{ 0 comments ... read them below or add one }

Post a Comment

 
© onlajer,Net All Rights Reserved
OnLajer